Zenith VRL4110 - VHS Tape Playback

Playback
•
=
3.
=
J
/
Powilr
IrFO_EJI_2T
l J'- U
VRL4110.4HEADS(D_.ON I SCREEN PROGRAMMING.HQ
®
Turn the TV on and tune it to Channel 3.* (If you have
a Zenith TV use the remote control, press 3, then
ENTER.)
Switch the remote control to VCR mode.
Insert a VHS cassette tape into the VCR loading com-
partment; this turns on the power and the tape will
automatically begin playing if the cassette safety tab has
been removed, or press PLAY on the VCR or the
remote control to start playing the tape.
To stop playing the tape press STOP/EJECT on the
VCR or STOP on the remote control. Press
STOP/EJECT on the VCR again to eject the tape.
Note: The symbols shown on this illustration in the
VCR message center will only appear while the VCR is
performing those functions. However, the clock will
remain on while power is supplied to the VCR.
Automatic Reset-The counter resets when you insert a
tape and when a tape is rewound to its beginning.
Display Elapsed Time- Press ENTER on the remote
control; press it again to leave the tape counter display
on the TV screen.
To Remove Counter Display-Press ENTER on the
remote control.
* Or 4, the same channel that you setwith the CH3-4
switch on the back of the VCR to send the VCR signal
tO the TV set.
SELECT OUIT
®®®
®®®
®®®
Q ( )
_-o 6-- 1