VRL 4110 Quick Reference Guide
Recording Using the Timer
(Recording while you are away.)
Turn on both the TV set and VCR. (You must
have specified either TV or CATV in the Tuning
Features submenu, see Installation Section.)
Insert a VHS video cassette tape into the cassette
loading compartment on the front of the VCR.
Make sure the safety tab on the video cassette is
intact.
Select Channel 3 on the TV set.
Change the remote control to VCR mode.
Press MENU on the remote control to choose the
Main Menu (VCR FEATURES).
Select 2-PROGRAM RECORD.
Enter the required information using the remote
control. Date of the Program. Start Time and
Stop Time. Choose the Channel. Choose the
Recording Speed. Choose the number of times
you want to record this program, Once, Weekly
(1 time each week) or Daily (the same time each
day Monday through Friday).
When finished programming the Timer, press
TIMER once to turn off the VCR and set it into
TIMER RECORDING mode.
Note: The VCR cannot be turned on while it is in
the TIMER mode. If you want to use the VCR
before your recorded program broadcast time,
press TIMER on the remote control to release
the VCR from the TIMER mode. Once the
TIMER is activated TMR will appear in the VCR
message center.
When the program comes on that you wish to
record you can also watch it, press TV/VCR once
on the remote control then turn on the TV set
and tune it to channel 3.
Note: For recording CATV (cable) broadcasts
the cable box must be on and tuned to the same
channel you wish to record.
When the timed program is finished press
TIMER then the VCR will be released from the
Timer mode.
Recording with a Camcorder
Turn on the TV set and the VCR.
Press MENU on the remote control to choose
the Main Menu (VCR FEATURES).
Choose 4-TUNING FEATURES; press the num-
ber 4 key. This brings up the TUNING FEA-
TURES submenu.
Press number 4 to choose SOURCE SELECT.
Press ADJ to place the arrow next to the word
AUX. Camcorders use the AUX inputs. (When
finished recording you will reset the arrow so it
points to TUNER).
Connect the camcorder cables into the VIDEO
IN, AUDIO IN jacks on the back of the VCR.
Insert a VHS cassette into the VCR cassette
loading compartment. Make sure the safety tab is
intact.
Turn on the camcorder and start recording.
(Refer to camcorder operating guide for informa-
tion about camcorder particulars.) To stop
recording momentarily, press PAUSE on the
remote control. When finished recording press
STOP on the remote control or the VCR. To
eject the tape press STOP/EJECT on the VCR
twice.
When you are finished with the camcorder, the
VCR source select option will have to be
switched back to TUNER.
Press MENU on the remote control.
Press 4 to choose TUNING FEATURES.
Press number 4 to choose SOURCE SELECT.
When that sub-menu comes up on the TV screen
press ADd to place the arrow so it is next to the
word TUNER; this resets the VCR back to nor-
mal VCR mode.
_o_o QRG -- 2
To Next Page
Loading...
