Zepro Z3N - Page 19

Control cards
19www.zepro.com
2.1.9 Outputs
Theoutputsectionisusedforpowerdeliverytothesolenoidandthevalvecoils.Itconsistsof10pinsintotal
out of which four are interconnected in two pairs for cases where two coils need the same signal. The U0 output
is reserved for the motor solenoid. U1-U3 are usualy used for valves V1, V2 and V3. U4 and U5 are usually used
for the safety valves on the tilt and lift cylinders and the remaining ouput pins are used for adidional valves.
See the functional descriptions and schematics chapter for more information.