ZiLOG System 8000 Hardware Reference Manual

HRM
COMMAND NAf'JIE
BREAK
SYNTAX
B [<address>] [<n>]
DESCRIPTION
Zilog
HRM
The BREAK command sets a breakpoint at a given even address
after clearing any previously set breakpoint. If <n> is
given, program execution is not interrupted until the nth
time the breakpoint instruction is encountered «n> is in
the ran ge %1- %FFF F). I f < n> i s not gi v en, 1 i s ass um ed . I f
the BREAK command is issued with no parameters, any previ-
ously set breakpoint is cleared. When program execution is
suspended by the BREAK command, the Monitor Program clisplays
a message reporting the break and the address where it
occurred.
EXAMPLE
[B 6A5E <CR>
Message: BREAK AT 6A5E
EXAMPLE
[D 8000 <CR>
<00> 8000 (XXXX)? <8D07> <CR>
<00> 8002 (XXXX)? <Q> <CR>
[B 8002 <CR>
[J 8000 <CR>
BREAK AT 8002
[
5-22
Zilog
5-22

ZiLOG System 8000 Specifications

General

Brand	ZiLOG
Model	System 8000
Category	Desktop
Language	English