ZiLOG System 8000 Hardware Reference Manual

HRM
COMMAND NAME
LOAD
SYNTAX:
L <filename>
DESCRIPTION:
Zilog
HRM
This command downloads a Z8000 program named <filename>
that resides in the remote system.
The Monitor Program transmits the exact command line to
the- remote system. The command causes a remote pro-
cedure file (LOAD) to be executed, to open the file
specified by <filename>. The binary data in the file is
converted to Tektronix record format and transmitted to
the local system. The Monitor Program verifies the two
checksum values in the receiving record and stores the
. data in RAM memory as specified by the address indicated
in the record. An acknowledgement from the system
causes the next record to be downloaded from the remote
system. A nonacknowledgement from the remote system
causes the current record to be ret~ansmitted up to ten
times, after which a record with an error message is
s~nt, and the .Monitor Program returns to Monitor Mode.
The
LOAD program in the remote system is also aborted.
Whe~ the loading process is completed, the entry point
received on the first record is displayed. Pressing ESC
aborts the LOAD command. Any breakpoints set from a
previous program must be cleared before a new program is
loaded from the remote system. (NOTE: Ensure that the
remote system is connected to T1YO on the rear panel).
ERROR MESSAGES:
IABORT
IUNABLE TO OPEN FILE (XX), where (XX) is the ZEUS error
code from the remote system
IFILENAME ERROR
INOT PROCEDURE FILE
IERROR IN READING FILE (XX), where (XX) is the ZEUS error
code from the remote system
IRECORD CHECKSUM ERROR
IINCORRECT LOAD ADDRESS
EXAMPLE:
Transfer file names MYFILE from the remote system to the
local system RAM memory.
5-37
Zilog
5-37

ZiLOG System 8000 Specifications

General

Brand	ZiLOG
Model	System 8000
Category	Desktop
Language	English