ZiLOG System 8000 - Page 272

HRM Zilog
o read = READ commands
o
size = SIZE commands
o
inv = "i.nvalid" packet commands
NOTE
Only SMDMON Ccln issue invalid commands through the
DOPKT command. These commands are tallied as
invalid, even though they may be valid commands.
HRM
Tallies of ~ll soft errors reported by the SMD con-
troller after execution of a packet command, including:
o TOTAL = the number of times one or more error
status bits (SB) were returned, but the ending status
(ES) indicated no uncorrectable errors occurred.
o rty = soft errors with retries attempted
o corr = soft errors with correction attempted
o rz = soft errors with a disk rezero attempted
Tallies of all uncorrected (hard) data errors reported
by the SMD controller after execution of a packet com-
mand, including:
o TOTAL = the number of times a hard data error was
returned in the ending status
o rty = hard data errors with retries attempted
o corr = hard data errors with correction attempted
o rz = hard data errors with a disk rezero attempted
Tallies of drive errors encountered during execution of
packet commands, including:
o TOTAL = the number of times one or more drive errors
occurred during execution of a packet command
o
df = drive faults
o se = drive seek errors
o noc = drive not-on-cylinder errors
o nrdy = drive not ready errors
o busy = dual-access busy errors
Tallies of all SMD controller timeout errors during
packet command execution, including:
o TOTAL = the total number of timeout errors
o idle = timeouts in the controller's idle loop
o ius = timeouts waiting for IP/IUS to clear
A- !l1
Zilog
A-41