ZiLOG System 8000 - Page 300

HRM
EX:\f.'lPLE:
HELP
Zilog
HRM
COMMAND: ICYL incval / IHEAD incval / ISEC incval
DESCRIPTION:
ICYL,
IHEAD and ISEC increment the current values of
cyl, head, and sec by incval, respectively.
An increment of sec up to or greater than maxsec causes
SMDMON to increment head and cyl by the correct
amounts. An increment of head up to or greater than
maxhead causes SMDMON to increment cyl the correct
amount. If cyl will be equal or greater than rnaxcyl,
however, SMDMON ignores the command.
EXAMPLE:
SALL 588 0 0
ISEC 45
IHEAD 8
Assuming the drive is an 80 Megabyte drive with maxcyl
: 589, max head : 7, maxsec : 32, the ISEC command
causes SMDMON to set cyl:588, head:1, sec:12. The
IHEAD command is ignored, because it would set cyl to
589, which is equal to maxcyl.
COMMAND: ILNTH offinc / IROFF offinc / IWOFF offinc
DESCRIPTION:
ILNTH increments the current read/write buffer length
by offinc.
IROFF increments the current read buffer offset, roff,
by offinc.
IWOFF increments the current write buffer offset, woff,
by affine.
offinc is the parameter value supplied, or takes on its
previous or default value, if absent. It must always
be an even number.
EXAMPLE:
A-69
Zilog
A-69