ZiLOG System 8000 - Page 306

HRM
contents.
EXANPLE:
READ
STATUS
Zilog
HRM
The STATUS shows the current unit status.
COMMAND: SUNIT unit
DESCRIPTION:
If NO parameter is given, this command shows the
current unit number. If a parameter is given, SUNIT
sets the current disk unit to the parameter value as
well as retrieving the drive-size parameters stored in
a table. The format parameters are also changed. The
drive-size and format parameters change as follows:
maxcyl = # of cylinders on drive (per table)
maxhead = # of heads on drive (per table)
maxsec = # Active sectors/track (per table)
fmtsec = new max sec value + 1
nsec = new max sec value +
fspare = new maxsec value
fbad = ffffH
maxcyl, maxhead and max sec are used to do boundary
checking on commands that increment the disk address.
fmtsec, nsec, fspare & fbad are parameters used during
FMT, FVOL and FRD commands.
EXAMPLE:
SUNIT
SUNIT
The first line does not change the current unit,
because there is no parameter given. It simply
displays the current disk unit. No drive-size or for-
mat parameters are affected.
The second line sets the current unit to 1. The
drive-size and format parameters change according to
the values stored in a table in SMDMON.
COMMAND: SWSEG wseg / SWOFF woff
DESCRIPTION:
A-75
Zilog .
A-75