ZiLOG System 8000 - Page 60

HRM Zilog HRM
(5) The terminal used for system bootstrap should be con-
nected to the terminal I/O port labeled CONSOLE.
(6) Connect the user terminals, as required, to the termi-
nal I/O ports labeled TTYO, or TTY2 through TTY7.
(7) If the system is configured for the 16 user option,
cable the Processor Module I/O panel OPTION connector
to the second terminal distribution panel TERMINAL IN
connector. Connect the next eight (8) terminals to I/O
ports TTY8 through TTY15, on the second terminal dis-
tribution panel.
(8) Connect the line printer interface cable to the first
terminal distribution panel parallel port labeled
PRINTER 1.
(9) If an additional terminal distribution panel is sup-
plied with the system, connect the printer interface
cable to the I/O ports labelled PRINTER 2.
(10) Connect the system, all terminals, and the
printer(s) to facility AC power.
line
3-9
Zilog
3-9