802742UK - G4 IS IT industrial installation instructions - Jan. 2016 - V2.03 Page 17 of 32
Template for industrial side touch taps
USE THIS DRILLING TEMPLATE WHEN MOUNTING TO THE LEFT HAND
SIDE OF THE FONT OR SINK
PLAN VIEW
SCALE 1:1
BUTTONS FACE USER
THIS SIDE
MATCH TEMPLATE TO CLAMP BLOCK AND TAP BEFORE DRILLING HOLES TO
• ENSURE TAP SPOUT POSITION CORRESPONDS TO THE DIRECTION
PRESCRIBED ABOVE
• ENSURE THAT NO SCALING HAS TAKEN PLACE DURING PRINTING
DRILL 3 X Ø6.5mm HOLES ON
A Ø43.0 P.C.D, EQUISPACED
DRILL 1 X Ø35.0mm HOLE
TAP
SPOUT
To Next Page
Loading...
