SmartLPR
®
Access User Manual Configuration
Quercus Technologies 38
5.3. “Multi-unit configuration”
Press on “Multi-unit configuration” menu to see all the units found in the system. Click on the
icon that represents a camera to adjust the focus/zoom of each unit; once you have adjusted all
the units, go back to “Multi-unit configuration” tab. We will see a list with all the units found in
the system each of them with its IP address, description and firmware version.
Click on “Refresh” to refresh this list and “Save changes” to save the changes made in this
section.
To Next Page
Loading...