SmartLPR
®
Access User Manual Configuration
Quercus Technologies 40
● RECOGNITION: configuration of the recognition engine of the unit.
● WorkingMode: the operation mode of the unit. Possible values:
● Software: it is the central system that determines when the plate recognition
should take place.
● Hardware: the unit detects vehicle movements and determines when the
recognition should take place (every time a new vehicle arrives).
● Pre-trigger: the unit is continually recognizing license plates as vehicles are
approaching and internally stores the best recognition. When the client
application request the license plate, the unit immediately sends it.
● Pre-arming loop: the unit directly receives from a loop installed at the
beginning of the lane a signal indicating the recognition must start. When the
client application sends a recognition request, SmartLPR
®
Access sends the best
recognition result.
● Regions: the available regions are on the left and the ones you have selected on the
right. Too add or remove regions, use the arrows. Also use the arrows to define the
priority order in the "Current" column.
● Advanced settings: variables for the advanced configuration, only available to
expert users.
To Next Page
Loading...
Need help?
General