43
Atlas x00 Series Access Control Panels Installation Guide
Special Considerations for Complex Networks
If all Atlas Series controllers cannot be located on one network subnet, or if Dis-
covery is blocked by network restrictions, observe the following.
• There is no dierence in the way you set up the primary controller.
• During “Initial Controller Setup” of secondary controllers on other subnets, do
not select DHCP as normally recommended. Assign these controllers static IP
addresses.
• Manually add these secondary controllers in the Web Management Applica-
tion. Log in and read “Manually Adding Secondary Controllers” in the help
topic, “Conguration: Hardware: Adding Controllers.”
Where to Go Next
A complete user manual is available through the Management Application by
selecting “Help” from the menu in the upper right corner.
The help’s “Introduction” page will guide you to more information on operating
the application, changing the conguration of controllers and doors, setting up
door access, using emergency features, and more.
ETL Certication
Resistance to attack Level I;
Line security Level I;
Endurance Level I.
To Next Page
Loading...
Need help?
General
