ZKTeco Atlas 00 Series User Manual

6
Atlas x00 Series Access Control Panels Installation Guide
Product PIN Diagram
Ethernet Port
Atlas Power
Figure 1
4 Lock & Door Sensor
Aux Input
RESET
Aux Output
Power Detection
USB Port
Wiegand
Reader 3
WIFI
Wiegand
Reader 4
Wiegand
Reader 1
Wiegand
Reader 2
OSDP
Reader
Status Indicator
The function of reset button (once reset button is pressed, LED will blink fast):
1. Press reset button for about 2-5 seconds, zk firmware will check if there is a USB disk which stores an upgrade package
inserted into controller, if yes, then controller will do firmware upgrade automatically.
2. Press reset button for about 5-10 seconds, zk firmware will temporarily set IP to default 169.254.202.242.
RS485 Comm. (not used)
(POE)

ZKTeco Atlas 00 Series Specifications

General

Brand	ZKTeco
Model	Atlas 00 Series
Category	Control Panel
Language	English