To Next Page

To Previous Page

Atlas Bio Series Access Control Panels Installation Guide

If all controllers of the Atlas Series can not be located on a single network subnet, or if Discovery is hindered by

network restrictions, observe the following:

• There is no dierence in the way you set up the primary controller.

• While “Initial Controller Setup” of secondary controllers on other subnets, do not select DHCP as normally

recommended. Assign these controllers static IP addresses.

• Manually add these secondary controllers in the Web Management Application. Log in and read “Manually

Adding Secondary Controllers” in the help topic, “Conguration: Hardware: Adding Controllers”

Where to Go Next

A complete user manual is available through the Web Management Application by selecting “Help” from the

menu in the upper right corner.

The help’s “Introduction” page will guide you to more information on operating the application, changing the

conguration of controllers and doors, setting up door access, using emergency features, and more.

ETL Certication

Resistance to attack Level I

Line security Level I

Endurance Level I

Standby Power Level I

11. Special Considerations for Complex Networks

ZKTeco Atlas Bio Series User Manual

Questions and Answers: