ZOLL PD 2000 - Page 37

CHECKOUT PROCEDURES
Normal Sinus NO SHOCK ADVISED
Ventricular Fibrillation SHOCK ADVISED
Asystole NO SHOCK ADVISED
8.4 TEST PROCEDURE
+ Set the energy level to 2].
e With the MFC installed but not plugged into the test connector,
charge the PD™ 1400-series device to 2).
e Press both DISCHARGE buttons.
Verify that the message "ELECT. PADS OFF" appears.
Mark the Checkout Procedure Data Sheet.
8.5 TEST PROCEDURE
Plug the MFC into the test connector (ZOLL part number 1004-0053).
» If the unit is not still charged, charge it to 2].
« Discharge into the test connector.
Verify that the unit successfully discharges into the load by checking that
the screen message changes back to "2J SEL".
Mark the Checkout Procedure Data Sheet.
8.6 TEST PROCEDURE
WARNING
+ Limit internal discharges to 100 Joules or less. Do not
discharge the PD™ 1400-series device internally more
than 3 times in one minute. Multiple internal discharges
at more than 100 Joules maydamage the unit.
+ All persons near the equipment must be warned to
"STAND CLEAR“ prior to defibrillator discharge.
With the MEC still plugged into its test connector, charge the
unit to 100J and discharge.
Verify: The message "TEST OK" appears on the CRT.
The message "TEST OK" appears on strip chart.
1-25