ZOLL PD 2000 - Page 55

SERVICE MANUAL
PD™ 1400-SERIES TEXT MESSAGES (CONTINUED)
Text Messages Description
DISABLE SYNC
(PD™ 2000/D 2000 only) Displayed
if the ANALYZE button is pressed
and the device isin SYNC DEFIB |
mode. The unit should be taken out
of SYNC mode by pressing the
SYNC button before attempting to
activate Advisory Analysis
ANALYSIS HALTED
(PD™ 2000/D 2000 only} Analysis
was halted due to either an ECG that
was detected as too noisy or due to
the operational mode of the unit
being switched during analysis
VF ALARMS OFF
(PD™ 2000/D 2000 only) This
indicates that the advisory analysis
will not be performedwhen Heart
rate alarms are enabled while in pace
mode
SEL. ELECTRODES
(PD™ 2000/D 2000 only) Displayed
if the ANALYZE button is pressed
and the device is in SYNC DEFIB
mode. The unit should be taken out
of SYNC mode by pressing the
SYNC button
ECG TOO LARGE
ADJUST ECG GAIN
If the ECG signal is too large during
advisory analysis, this message will
prompt the user to decrease the ECG
gain.
NOISY ECG
RETRY ANALYSIS
This message indicates that the
advisory analysis algorithm
determined that the ECG signal was
too noisy to properly determine the
rhythm characteristics.
DI-4