ZOLL PD 2000 - Page 54

TROUBLESHOOTING GUIDES
PD™ 1400-SERIES TEXT MESSAGES (CONTINUED)
Text Messages Description
CANNOT CHARGE Both discharge buttons are pressed
and charge button is pressed. Also
when XSAFE = 0 and CHARGE
bution is pressed while STATUS 66 is
being displayed.
CANNOT DUMP DEFIB Capacitor voltage above
target and still charging while not in
charge made.
PACE FAULT VMON is rising in Pace Mode
TEST OK CPU detected IPEAK test and unit
_ passed.
TEST FAIL CPU detected IPEAK test and unit
failed.
50 J MAX
The unit will charge to a maximum
of 50} with internal paddles.
ELECT. PADS OFF
Detected electrodes are off during
impedance test prior to DEFIB
discharge or Advisory analysis.
USE LEADS Use ECG leads instead of paddles for
synchronized cardioversion.
-一 一 -一 一 一 Serial link error. Dashed lines also
show up on stripchart.
SELECT
DEFIB.
(PD™
2000/D
2000
only)
This
message will occur if the ANALYZE
push-button is pressed when
operating in the MONITOR ON or
PACER ON mode. (PD™ 2000 only).
Move the selector switch to DEFIB
ON/ANALYZE to enable the
defibrillator and advisory capabiltiy.