ZOLL PD 2000 - Page 58

PD™
1400-SERIES
STATUS
MESSAGES
(CONTINUED)
TROUBLESHOOTING GUIDES
Error
Type of
Number Description Problem
STATUS 91 CPU DEFIB - Maximum allowable time has Defib
been exceeded without reaching target module
energy. -
STATUS 104 CPU and EPU target energies did not agree EPU
during defib charge. monitor
module
STATUS 107 Defib cap has reached its absolute maximum | EPU
voltage as detected by the EPU. monitor
module
STATUS 108 During EPU monitor processing, CPU mode | EPU
is other than IDLE, CHARGING, or READY. | monitor
(diagnostic mode only) module
STATUS 110 Pulse width greater than 16 ms as measured | EPU
by EPU during defib impedance test, monitor
module
STATUS 113 Target error (diagnostic mode only). EPU
: monitor
module
STATUS 123 During pace pulse, pulse width measured by | EPU
the EPU is < 30 ms or > 50 ms. (diagnostic monitor
mode only). module
STATUS 124 EPU VSNS sample or average sample is out EPU
of set limits. (diagnostic mode only). monitor
module
STATUS 125 During pace pulse, pulse period as EPU
measured by EPU is < selected period minus | monitor
40 ms. (diagnostic mode only). module
STATUS 126 No pace current measured by EPU within 40 | EPU
ms of pace pulse marker. (diagnostic mode monitor
only). module
STATUS 127 CPU is in pace mode but XPACE SEL signal | EPU
to the EPU indicates that the SELECTOR monitor |
SWITCH is not in pace mode. | module
111-7