4 5
Effect Types and Parameters
[ DYNAMICS ]
1176 LIMITER This is a simulation of the UREI 1176LN.
INPUT Adjusts the input level. 0 – 80
RATIO Adjusts the compression ratio.
4:1, 8:1, 12:1,
20:1
RELEASE This is a limiter that suppresses signal peaks above a certain reference level. 10 – 70
OUTPUT
Adjusts the output level. 0 – 80
ZOOM
NOISE
REDUCTION
ZOOM's unique noise reduction cuts noise during pauses in playing without affecting
the tone.
DETECT Sets control signal detection level.
GTRIN,
EFXIN
DEPTH Sets the depth of noise reduction. 0 – 100
THRSHLD Adjusts the effect sensitivity. 0 – 100
DECAY Adjust the envelope release. 0 – 100
SLOW
ATTACK
This effect slows the attack of each note, resulting in a violin-like performance.
TIME Adjusts the attack time. 1 – 50
CURVE Set the curve of volume change during attack. 0 – 10
TONE Adjusts the tone. 0 – 100
VOL Adjusts the volume. 0 – 100
[ FILTER ]
BASS AUTO
WAH
You can adjust the mix of this bass guitar auto-wah with the original signal.
SENSE Adjusts the sensitivity of the effect. -10 – -1, 1 – 10
RESO Sets effect resonance. 0 – 10
DRY Adjusts the volume of the unaffected sound. 0 – 100
VOL
Adjusts the volume. 0 – 100
ENVELOPE
FILTER
This models the MXR envelope filter.
THRSHLD Adjusts the effect sensitivity. 0 – 100
ATTACK Adjusts the attack speed. 0 – 100
MODE Sets direction of movement of the filter. UP, DOWN
VOL Adjusts the volume. 0 – 100
AUTO FILTER This is a resonance filter with a sharp envelope.
MODE Sets direction of movement of the filter. UP, DOWN
SENSE Adjusts the sensitivity of the effect. 1 – 10
PEAK Adjusts the Q value of the filter. 0 – 10
DRY
Adjusts the volume of the unaffected sound. 0 – 100
Z TRON
FILTER
This is like a Q-Tron Envelope Filter in LP mode.
SENSE Adjusts the sensitivity of the effect. -10 – -1, 1 – 10
RESO Sets effect resonance. 0 – 10
DRY Adjusts the volume of the unaffected sound. 0 – 100
VOL
Adjusts the volume. 0 – 100
To Next Page
Loading...
Need help?
General
