Setting the UNDO function
This turns on/off the undo function that can be used to undo the last recorded overdub of a loop.
1. Turn on the Looper Effect Setting Screen (→Setting the looper effect).
Setting Explanation
ON This enables the UNDO function.
OFF This disables the UNDO function.
NOTE:
The looper recording time is 1.5 – 30 seconds (15 when UNDO is ON) for stereo, and 1.5 – 60 seconds (30
when UNDO is ON) for mono. To switch between stereo and mono, see “Setting the looper effect”.
66
To Next Page
Loading...
