Zoom Cable Modem/Router User Manual


58
To activate the IP address filter:
1 Enter the last byte (the numbers after the last period) of the IP address in Start
Address and End Address.
2 Check the Enable box to the right of the entry to store settings.
3 Click the Apply button to activate the filter rules.
Table 9. IP Filtering Menu Option
Option Description
Start/End
Address
Enter the last byte of the IP address. The upper bytes of the IP
address are set automatically from the Cable Modem/Router IP
address.
Enable
To activate the IP address filter, you must also check the Enable box
and click Apply. You can disable this filter while retaining the
addresses you entered for later use.
MAC Filtering
The MAC Filtering page allows you to configure MAC address filters in order to block
Internet traffic to specific network devices on your LAN.
To access the MAC Filtering page:
1 Click Advanced in the menu bar.
2 Then click the MAC Filtering submenu.
Figure 15 shows an example of the menu and Table 10 describes the
items you can
select.

Zoom Cable Modem/Router Specifications

General

Brand	Zoom
Model	Cable Modem/Router
Category	Network Router
Language	English