32
Recording and playback
Preparing to record
Inserting SD cards
POWER switch SD card slot
1. Set to OFF.
2. Open the SD card slot cover, and insert an SD card all the way into the
slot.
To remove an SD card, push it further into the slot and then pull it out.
NOTE
• Disable write-protection on the SD card before inserting it.
• Always set
to OFF before inserting or removing an SD card.
Inserting or removing a card while the power is on could result in data loss.
• When inserting an SD card, be sure to insert the correct end with the top side up as shown.
• If an SD card is not loaded, recording and playback are not possible.
• To format an SD card, see P.81.
To Next Page
Loading...
