Zte H1600 - Page 32

24
SJ-20210621164956-008 | 2022-09-01(R1.3)
ZTE H1600 Maintenance Management Guide
Parameter
Description
SCR
Sustainable Cell Rate.
If Service Type is selected to be VBR-rt or VBR-nrt, SCR needs
to be configured.
MBS
Maximum Burst Size.
If Service Type is selected to be VBR-rt or VBR-nrt, MBS needs
to be configured.
Type
The connection type includes Routing and Bridge Connection.
In this case, Routing is selected.
Service List
Options: INTERNET, TR069 and VoIP.
This parameter must be consistent with service configuration.
For example, if INTERNET is selected, it indicates that the WAN
connection supports the Internet access service only. If TR069 is
selected, it indicates that the WAN connection supports remote
management.
MTU
Define the maximum transfer unit.
In this case, default value is 1492.
Link Type
There are two link types: PPP and IP.
PPP Transfer Type
In this case, default value is PPPoE.
If DSL Transfer Mode is selected to be ATM, PPP Transfer
Type includes PPPoE and PPPoA.
PPP
Username/Password
PPPoE user name and password.
They are provided by the ISP.
*Authentication Type
There are three authentication types:
⚫
Auto
⚫
PAP
⚫
CHAP
*Connection Mode
There are two connection modes:
⚫
Always On
⚫
On Demand
*PPPoE Pass-through
Enable or disable the PPPoE Pass-through function.The default
configuration is on.
IP Version
The IP version includes: IPv4, IPv6 and IPv4/v6
In this case, IPv4 is selected.
NAT
Enable or disable the NAT function.
IPv4