Zte H1600 - Page 46

38
SJ-20210621164956-008 | 2022-09-01(R1.3)
ZTE H1600 Maintenance Management Guide
Figure 4-18 Service Control-IPv6 Page
Table 4-10 lists the Service Control-IPv6 parameters.
Table 4-10 Parameter Descriptions for the Service Control-IPv6
Parameter
Description
On/Off
Click On to enable the function.
Click Off to disable the function.
Name
Name of the service control item.
The name must be specified.
Target
Specify to discard or permit the data packages.
Ingress
Specify the data stream inbound direction, and this parameter must
be specified.
⚫
If the Ingress is WAN, all the WAN connection can access ZTE
H1600.
⚫
If the Ingress is LAN, the LAN side can access ZTE H1600.
Prefix
IPv6 address prefix.
Service Type
Specify the service that is permitted or denied to access.
2. Click Apply button to apply the changes.
Configure the Remote Service Port Control-IPv4
1. Click Remote Service Port Control - IPv4 to open the Remote Service Port Con-
trol - IPv4 page, see Figure 4-19.