Zte H1600 - Page 63

SJ-20210621164956-008 | 2022-09-01(R1.3)
55
5 Configure the Local Network
Table 5-4 Access Control-Mode configuration parameters
Parameter
Description
No Filter
No filter is to be applied (the default).
Black List
Deny the WiFi network users to access specific address.
White List
Allow the WiFi network users to access specific address.
4. Click Apply button to apply the changes.
Configure the Access Control-Rule
1. Click Access Control-Rule Configuration to open the configuration page, see Fig-
ure 5-12.
Figure 5-12 Access Control-Rule Settings
2. Configure the access control-rule configuration parameters.Table 5-5 lists the access
control-rule configuration parameters.
Table 5-5 Access Control-Rule Configuration parameters
Parameter
Description
Name
The name of Access control item.
SSID
The SSID corresponding to the WiFi network to which the
rule is applied, the default value is SSID1.
MAC Address
The MAC address of the wireless device.
We suggest to set the MAC addresses in access control list
using a wireline connected device.
Modifying the list using a wireless device may cause unex-
pected disconnection of the device used
3. Click Apply button to apply the changes.