Zte ZXR10 5250-52TC - Ipv6 Layer 3 Configuration

Chapter5ServiceConguration
zte(cfg)#ping192.168.1.1
Replyfrom192.168.1.1:bytes=28time<1msTTL=64
Replyfrom192.168.1.1:bytes=28time<1msTTL=64
Replyfrom192.168.1.1:bytes=28time<1msTTL=64
Replyfrom192.168.1.1:bytes=28time<1msTTL=64
Replyfrom192.168.1.1:bytes=28time<1msTTL=64
5.16IPv6Layer3Conguration
IPv6Layer3FunctionOverview
TheZXR105250supportsIPv6layer-3functionsforremotecongurationand
management.TheLayer3functionsareasfollows:
1.IPv6interfaceconguration
2.Pingv6forcheckingnetworkconnectivity
3.Telnetv6serverforremoteloginandconguration
ConguringIPv6Layer3Functions
ThecongurationofIPv6Layer3functionsincludesthefollowingcommands:
CommandFunction
zte(cfg-router)#setipv6port<0>vlan<1-4094>SetsaVLANassociatedwithan
IPv6Layer3interface.
zte(cfg-router)#setipv6port<0>ipv6address
{<ipv6Addr/M>|<ipv6Addr><wildcard>}
SetsanIPv6addressandaddress
prexlengthofanIPv6Layer3
interface.
zte(cfg-router)#setipv6port<0>{enable|disable}EnablesordisablesanIPv6Layer
3interface.
zte(cfg-router)#ipv6routedefault<ipv6Addr>AddsanIPv6staticroute.
zte(cfg-router)#clearipv6port<0>[ipv6address
<ipv6Addr/M>]
ClearsIPv6Layer3interface
conguration.
zte(cfg-router)#clearipv6routedefaultClearstheIPv6defaultroute.
showipv6port(allcongurationmodes)DisplaysIPv6Layer3interface
conguration.
showipv6route(allcongurationmodes)DisplaysIPv6routeconguration.
showipv6port<0>nd(allcongurationmodes)DisplaysIPv6deviceneighbor
information,similartothefunction
oftheshowarpcommandinIPv4.
zte(cfg)#ping6<ipv6Addr>[<0-65535>[<48-1280>[<1-255>[<0-
65535>]]]]
Checksnetworkconnectivity,
similartothefunctionoftheping
commandinIPv4.
5-67
SJ-20131111172707-002|2013-11-27(R1.0)ZTEProprietaryandCondential