Dimension GS-3012 Gigabit Ethernet Switch
Introduction to CLI 28-15
Table 28-3 Command Summary: Configure Mode
COMMAND DESCRIPTION
classifier <name>
<[packet-format
<802.3untag|802.3ta
g|
EtherIIuntag|EtherI
Itag>] [priority
<0-7>]
[vlan <vlan-id>]
[ethernet-type
<ether-num|ip|ipx|
arp|rarp|
appletalk|decnet|
sna|netbios|dlc>]
[source-mac <src-
mac-addr>]
[source-port <port-
num>] [destination-
mac <dest-mac-
addr>]
[dscp <0-63> ]
[ip-protocol
<protocol-
num|tcp|udp|icmp|eg
p| ospf|rsvp|igmp|
igp|pim|ipsec>
[establish-only]]
[source-ip <src-ip-
addr> [mask-bits
<mask-bits>]]
[source-socket
<socket-num>]
[destination-ip
<dest-ip-addr>
[mask-bits <mask-
bits>]]
[destination-socket
<socket-num>]
[inactive]>
Configures a classifier. A classifier
groups traffic into data flows
according to specific criteria such
as the source address, destination
address, source port number,
destination port number or
incoming port number.
To Next Page
Loading...
