ZyXEL Communications Dimension GS-3012 - Figure 29-25 Gvrp Command Example; Figure 29-26 Ingress-Check Command Example

Dimension GS-3012 Gigabit Ethernet Switch
Command Examples 29-13
29.8.6 gvrp
Syntax:
gvrp
GVRP (GARP VLAN Registration Protocol) is a registration protocol that defines a way for switches to register
necessary VLAN members on ports across the network. Enable this function to permit VLANs groups beyond
the local switch.
An example is shown next.
Enable the IEEE 802.1Q tagged VLAN command to configure tagged VLAN for the switch.
Enable ports one, three, four and five for configuration.
Enable GVRP on the interface.
Figure 29-25 gvrp Command Example
29.8.7 ingress-check
Syntax:
ingress-check
Enables the device to discard incoming frames for VLANs that are not included in a port member set.
An example is shown next.
Enable ports one, three, four and five for configuration.
Enable ingress checking on the interface.
Figure 29-26 ingress-check Command Example
frame-type <all|tagged>
Choose to accept both tagged
and untagged incoming frames
or just tagged incoming frames
on a port.
29.8.8 frame-type
Syntax:
GS-3012(config)# vlan1q gvrp
GS-3012(config)# interface 1,3-5
GS-3012(config-interface)# gvrp
GS-3012(config)# interface 1,3-5
GS-3012(config-interface)# ingress-check