ZyXEL Communications Dimension GS-3012 - Figure 29-32 Qos Priority Command Example; Figure 29-33 Name Command Example

Dimension GS-3012 Gigabit Ethernet Switch
29-16 Command Examples
29.8.13 qos priority
Syntax:
qos priority <0 .. 7>
where
<0 .. 7>
Sets the quality of service priority for an interface(s).
An example is shown next.
Enable ports one, three, four and five for configuration.
Set the IEEE 802.1p quality of service priority as four (4).
Figure 29-32 qos priority Command Example
29.8.14 name
Syntax:
name <port-name-string>
where
<port-name-
string>
Sets a name for your port interface(s).
An example is shown next.
Enable ports one, three, four and five for configuration.
Set a name for the interfaces.
Figure 29-33 name Command Example
29.8.15 speed-duplex
Syntax:
speed-duplex <auto|10-half|10-full|100-half|100-full|1000-full>
where
GS-3012(config)# interface 1,3-5
GS-3012(config-interface)# qos priority 4
GS-3012(config)# interface 1,3-5
GS-3012(config-interface)# name Test