Dimension GS-3012 Gigabit Ethernet Switch
Getting to Know the GS-3012 1-5
Figure 1-2 Bridging Application
Full-duplex mode operation only applies to point-to-point access (for example, when attaching
the switch to a workstation, server, or another switch). When connecting to hubs, use a standard
cascaded connection set at half-duplex operation.
1.3.3 High Performance Switched Workgroup Example
The switch is ideal for connecting two power workgroups that need high bandwidth. In the following example, use
trunking to connect these two power workgroups.
Switching to higher-speed LANs such as FDDI or ATM is not feasible for most people due to the expense of
replacing all existing Ethernet cables and adapter cards, restructuring your network and complex maintenance.
The GS-3012 can provide the same bandwidth as FDDI and ATM at much lower cost while still being able to use
existing adapters and switches. Moreover, the current LAN structure can be retained as all ports can freely
communicate with each other.
To Next Page
Loading...
