ZyXEL Communications Dimension GS-3012 - Figure 29-21 Interface Bpdu-Control Command Example; Figure 29-22 Broadcast-Limit Command Example

Dimension GS-3012 Gigabit Ethernet Switch
Command Examples 29-11
<peer|tunnel|d
iscard|network
>=
Type peer to process any BPDUs received on these ports.
Type tunnel to forward BPDUs received on these ports.
Type discard to drop any BPDUs received on these ports.
Type network to process and forward BPDUs with a VLAN tag and
to process untagged BPDUs.
An example is shown next.
Enable ports one, three, four and five for configuration.
Set the BPDU control to tunnel, to forward BPDUs received on ports one, three, four and five.
Figure 29-21 interface bpdu-control Command Example
29.8.3 broadcast-limit
Syntax:
broadcast-limit
broadcast-limit <pkt/s>
where
Enables broadcast storm control limit on the switch.
<pkt/s>
Sets how many broadcast packets the interface receives per second.
An example is shown next.
Enable port one for configuration.
Enable broadcast control.
Set the number of broadband packets the interface receives per second
Figure 29-22 broadcast-limit Command Example
29.8.4 bandwidth-limit
Syntax:
bandwidth-limit
bandwidth-limit egress <Mbps>
bandwidth-limit ingress <Mbps>
where
GS-3012(config)# interface 1,3-5
GS-3012(config-interface)# bpdu-control tunnel
GS-3012(config-interface)#
GS-3012(config)# interface 1
GS-3012(config-interface)# broadcast-limit
GS-3012(config-interface)# broadcast-limit 21