Chapter 11 Static Multicast Forwarding
ES-2024 Series User’s Guide
103
Port Enter the port(s) where frames with destination MAC address that matched the entry
above are forwarded. You can enter multiple ports separated by (no space) comma (,)
or hyphen (-). For example, enter “3-5” for ports 3, 4, and 5. Enter “3,5,7” for ports 3,
5, and 7.
Add Click Add to save your rule to the Switch’s run-time memory. The Switch loses this
rule if it is turned off or loses power, so use the Save link on the top navigation panel
to save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to reset the fields to their last saved values.
Clear Click Clear to begin configuring this screen afresh.
Index Click an index number to modify a static multicast MAC address rule for port(s).
Active This field displays whether a static multicast MAC address forwarding rule is active
(Yes) or not (No). You may temporarily deactivate a rule without deleting it.
Name This field displays the descriptive name for identification purposes for a static
multicast MAC address-forwarding rule.
MAC Address This field displays the multicast MAC address that identifies a multicast group.
VID This field displays the ID number of a VLAN group to which frames containing the
specified multicast MAC address will be forwarded.
Port This field displays the port(s) within a identified VLAN group to which frames
containing the specified multicast MAC address will be forwarded.
Delete Click Delete to remove the selected entry from the summary table.
Cancel Click Cancel to clear the Delete check boxes.
Table 21 Advanced Application > Static Multicast Forwarding (continued)
LABEL DESCRIPTION
To Next Page
Loading...
