Chapter 22 AAA
ES-2024 Series User’s Guide
159
Figure 91 Advanced Application > AAA > RADIUS Server Setup
The following table describes the labels in this screen.
Table 50 Advanced Application > AAA > RADIUS Server Setup
LABEL DESCRIPTION
Authentication
Server
Use this section to configure your RADIUS authentication settings.
Mode This field is only valid if you configure multiple RADIUS servers.
Select index-priority and the Switch tries to authenticate with the first configured
RADIUS server, if the RADIUS server does not respond then the Switch tries to
authenticate with the second RADIUS server.
Select round-robin to alternate between the RADIUS servers that it sends
authentication requests to.
Note: If you are using two different RADIUS servers, select
round-robin in this field. If the designated server is not
available, the connection times out instead of trying
other available servers.
Timeout Specify the amount of time in seconds that the Switch waits for an authentication
request response from the RADIUS server.
If you are using index-priority for your authentication and you are using two
RADIUS servers then the timeout value is divided between the two RADIUS
servers. For example, if you set the timeout value to 30 seconds, then the Switch
waits for a response from the first RADIUS server for 15 seconds and then tries the
second RADIUS server.
Index This is a read-only number representing a RADIUS server entry.
IP Address Enter the IP address of an external RADIUS server in dotted decimal notation.
To Next Page
Loading...
