Chapter 17 IGMP
IES-612-51A User’s Guide
156
17.4 IGMP Bandwidth Screen
Use this screen to set up bandwidth requirements for multicast channels. To open this screen,
click Advanced Application, IGMP, Bandwidth Setup.
Figure 70 IGMP Bandwidth
The following table describes the labels in this screen.
The first table displays the names of the fields. The subsequent tables show the
settings of the IGMP groups.
Index This is the IGMP group index number.
VID The VID is the VLAN ID on which the IGMP group is created.
IP Address This is the IP address of an IP multicast group member.
1~12, enet1, enet2 These columns indicate whether or not each port is a member of the IGMP
snooping group.
Table 35 IGMP (Status) (continued)
LABEL DESCRIPTION
Table 36 IGMP Bandwidth
LABEL DESCRIPTION
Port Setup Click Port Setup to open the Bandwidth Port Setup screen where you can set
up multicast bandwidth requirements on specified ports (see Section 17.4.1 on
page 157).
Default Bandwidth Enter the default bandwidth for multicast channels for which you have not
configured bandwidth requirements.
To Next Page
Loading...
