ZyXEL Communications IES-612-51A - Transparent LAN Service (TLS) Commands; TLS PVC Delete Command; TLS PVC Set Command

Chapter 53 Virtual Channel Management Commands
IES-612-51A User’s Guide
396
53.9 Transparent LAN Service (TLS) Commands
" You can NOT configure PPPoA-to-PPPoE and TLS settings on the same PVC.
53.9.1 TLS PVC Delete Command
Syntax:
ras> adsl tlspvc delete <portlist> <vpi> <vci>
where
This command clears TLS settings for the PVC.
53.9.2 TLS PVC Set Command
Syntax:
ras> adsl tlspvc set <portlist> <vpi> <vci> <DS vcprofile[,US vcprofile]>
<pvid> <priority>
where
pppoe srvcname
error
=
The number of service name errors; for example, the IES-
612-51A’s specified service is different than the BRAS’s
setting.
pppoe ac system
error
=
The number of times the access concentrator experienced an
error while performing the Host request; for example, when
resources are exhausted in the access concentrator. This
value does not include the number of times the IES-612-
51A checks the AC name field in the BRAS's reply PDU
and finds a mismatch, however.
pppoe generic
error
=
The number of other types of errors that occur in the PPPoE
session between the IES-612-51A and the BRAS.
<portlist> =
The port number of the TLS PVC. You can specify a single
DSL port <1>, all DSL ports <*> or a list of DSL ports
<1,3,5>. You can also include a range of ports <1,5,6~10>.
<vpi> =
The VPI of the TLS PVC.
<vci> =
The VCI of the TLS PVC.
<portlist> =
The port number of the TLS PVC. You can specify a single
DSL port <1>, all DSL ports <*> or a list of DSL ports
<1,3,5>. You can also include a range of ports <1,5,6~10>.
<vpi> =
The VPI of the TLS PVC.