ZyXEL Communications IES-612-51A - PPVC Member Delete Command; Figure 264 PPVC Member Set Command Example

Chapter 53 Virtual Channel Management Commands
IES-612-51A User’s Guide
381
This command adds a member PVC to a PPVC. You must create the PPVC before you use this
command to add a member.
" Only the member PVCs need to be created on the subscriber’s device.
The following example adds a PVC to a PPVC with VPI 8 and VCI 35 for port 5. The PVC
uses VPI 8 and VCI 36. It sets the DEFVAL profile for downstream traffic shaping and for
upstream traffic policing. It uses priority queue 2.
53.5 PPVC Member Delete Command
Syntax:
ras> adsl ppvc member delete <portlist> <vpi> <vci> <member vpi> <member
vci>
where
This command removes a PVC from a PPVC.
[,US
vcprofile]>
=
Assign a VC profile to use for policing this channel’s
upstream traffic. The IES-612-51A does not perform
upstream traffic policing if you do not specify an upstream
VC profile.
<level> =
The priority queue (0~7) to use for this PVCs traffic. 7 is the
highest priority.
Figure 264 PPVC Member Set Command Example
ras> adsl ppvc member set 5 8 35 8 36 DEFVAL,DEFVAL 2
<portlist> =
The port(s) of the PPVC.
You can specify a single DSL port <1>, all DSL ports <*>
or a list of DSL ports <1,3,5>. You can also include a range
of ports <1,5,6~10>.
<vpi> =
The VPI of the PPVC.
<vci> =
The VCI of the PPVC.
<member vpi> =
The VPI of the individual PVC that you are removing from
the PPVC.
<member vci> =
The VCI of the individual PVC that you are removing from
the PPVC.