ZyXEL Communications IES-612-51A - Packet Filter Pppoe Only Command; Figure 192 Packet Filter Set Command Example; Figure 193 Packet Filter Pppoe Only Command Example

Chapter 48 Packet Filter Commands
IES-612-51A User’s Guide
329
The following example sets DSL port 5 to reject ARP, PPPoE and IGMP packets.
48.1.3 Packet Filter PPPoE Only Command
Syntax:
ras> switch pktfilter pppoeonly <portlist>
This command sets the IES-612-51A to allow only PPPoE traffic on the specified DSL port(s).
The system will drop any non-PPPoE packets.
The following example sets DSL port 1 to accept only PPPoE packets.
Figure 192 Packet Filter Set Command Example
ras> switch pktfilter set 5 arp pppoe igmp
Figure 193 Packet Filter PPPoE Only Command Example
ras> switch pktfilter pppoeonly 1