ZyXEL Communications IES-612-51A - Figure 9 Installation Overview; Typical MDF Scenarios

Chapter 3 Front Panel
IES-612-51A User’s Guide
53
Figure 9 Installation Overview
" You can also attach RJ-11 connectors to the Telco-50 cable and connect
directly to a DSL modem(s) or patch panel. This chapter discusses
connections using MDFs.
3.2.7 Typical MDF Scenarios
This section describes typical installation scenarios.
3.2.7.1 Installation Scenario A
You want to install the IES-612-51A in an environment where there are no previously installed
MDFs. There is no phone service and you want to install the IES-612-51A for data-access
only. No connections from the CO lines are necessary.
You may connect using an MDF or attach RJ-11 connectors to the non-IES-612-51A end of
the Telco-50 cable and then connect to DSL modems directly.