ZyXEL Communications IES-612-51A - Annex M Enable Command; Annex M Disable Command; Annex I Enable Command; Figure 236 Annex L Disable Command Example

Chapter 52 ADSL Commands
IES-612-51A User’s Guide
356
Figure 236 Annex L Disable Command Example
52.1.20 Annex M Enable Command
This command turns on the Annex M double upstream feature on the specified ADSL2/2+
port(s). This has the upstream connection use tones 6 to 63.
Syntax:
ras> adsl annexm enable <portlist>
The following example turns on the Annex M feature for port 5.
Figure 237 Annex M Enable Command Example
52.1.21 Annex M Disable Command
This command turns off the Annex M double upstream feature on the specified ADSL2/2+
port(s).
Syntax:
ras> adsl annexm disable <portlist>
The following example turns off the Annex M feature for port 5.
Figure 238 Annex M Disable Command Example
52.1.22 Annex I Enable Command
This command turns on the Annex I all digital mode feature on the specified ADSL2/2+
port(s). With Annex I, the DSL connection uses the full spectrum of the physical line and the
user can not use POTS or ISDN service.
Syntax:
ras> adsl annexi enable <portlist>
The following example turns on the Annex I feature for port 5.
ras> adsl annexl disable 5
ras> adsl annexm enable 5
ras> adsl annexm disable 5