Chapter 52 ADSL Commands
IES-612-51A User’s Guide
363
An example is shown next.
See Table 95 on page 362 for details about these counters.
52.2.7 Line Diagnostics Set Command
Syntax:
ras> adsl linediag setld <port number>
This command has the IES-612-51A perform line diagnostics on the specified port. The DSL
port must be set to ADSL2 or ADSL2+ operational mode and have a connection. It takes about
one minute for the line diagnostics to finish.
The following example performs line diagnostics on DSL port 1. The screen displays a
message confirming upon which DSL port line diagnostics will be performed.
52.2.8 Line Diagnostics Get Command
Syntax:
ras> adsl linediag getld <port number>
Use this command to display the line diagnostics results after using the line diagnostics set
command on a DSL port. Use the line diagnostics results to analyze problems with the
physical DSL line.
Figure 246 1Day Performance Command Example
ras> statistics adsl 1dayperf 1
Port 1 current 1 day elapsed time:81985 sec (Link Down)
Current 1 Day Perf ATUC ATUR
lofs 0 0
loss 0 0
lols 0 -
lprs - 0
es 0 0
init 0 -
ses 0 0
uas 0 0
Port 1 previous 1 day elapsed time:0 sec
Previous 1 Day Perf ATUC ATUR
lofs 0 0
loss 0 0
lols 0 -
lprs - 0
es 0 0
init 0 -
ses 0 0
uas 0 0
Figure 247 Line Diagnostics Set Command Example
ras> adsl linediag setld 1
Line- 1 set to Line Diagnostic Mode
To Next Page
Loading...
