Chapter 12 Routing
LTE3301 Series User’s Guide
101
12.3 Dynamic Routing Screen
Use this screen to enable and configure RIP on the LTE3301. Click Network > Routing >
Dynamic Routing to open the Dynamic Routing screen.
Figure 66 Network > Routing > Dynamic Routing
The following table describes the labels in this screen.
IP Subnet Mask Enter the IP subnet mask here.
Gateway IP
Address
Enter the IP address of the next-hop gateway. The gateway is a router or switch on the
same segment as your LTE3301's interface(s). The gateway helps forward packets to their
destinations.
Back Click Back to return to the previous screen without saving.
Apply Click Apply to save your changes back to the LTE3301.
Cancel Click Cancel to set every field in this screen to its last-saved value.
Table 43 Network > Routing > Static Route: Add/Edit
LABEL DESCRIPTION
Table 44 Network > Routing > Dynamic Routing
LABEL DESCRIPTION
Dynamic Routing RIP (Routing Information Protocol) allows a router to exchange routing information with
other routers. The RIP version controls the format and the broadcasting method of the RIP
packets that the LTE3301 sends (it recognizes both formats when receiving). RIP version
1 is universally supported but RIP version 2 carries more information. RIP version 1 is
probably adequate for most networks, unless you have an unusual network topology.
Select the RIP version from RIPv1 and RIPv2. Otherwise, select Disable to turn if off.
Apply Click Apply to save your changes back to the LTE3301.
Cancel Click Cancel to begin configuring this screen afresh.
To Next Page
Loading...
