Chapter 1 Introduction
LTE3301 Series User’s Guide
13
WPS allows you to quickly set up a wireless network with strong security, without having to
configure security settings manually. Each WPS connection works between two devices. Both
devices must support WPS (check each device’s documentation to make sure).
Depending on the devices you have, you can either press a button (on the device itself, or in its
configuration utility) or enter a PIN (a unique Personal Identification Number that allows one device
to authenticate the other) in each of the two devices. When WPS is activated on a device, it has two
minutes to find another device that also has WPS activated. Then, the two devices connect and set
up a secure network by themselves.
You can use the WPS button ( ) on the top panel of the LTE3301 to activate WPS in order to
quickly set up a wireless network with strong security.
1 Make sure the power LED is on (not blinking).
2 Press the WPS button for more than three seconds and release it. Press the WPS button on another
WPS-enabled device within range of the LTE3301.
Note: You must activate WPS in the LTE3301 and in another wireless device within two
minutes of each other.
For more information on using WPS, see Section 4.2 on page 30.
1.7 SIM Card Slot
The LTE3301 comes with a built-in 4G LTE module for 4G connections. To set up a 4G connection
using the built-in 4G LTE module, just insert a 4G SIM card into the SIM card slot at the back of the
LTE3301.
Note: You must insert the 4G SIM card into the card slot before turning on the LTE3301.
1.8 LEDs
Figure 1 Front Panel
Power
LAN
Internet
WLAN/WPS
LTE
LTE Signal
Strength
To Next Page
Loading...
