ZyXEL Communications LTE3301 Series - Tutorials for LTE3301 Configuration; Chapter 4 Tutorials Overview; Chapter 4 Tutorials Set Up Wireless Network Using WPS

LTE3301 Series User’s Guide
30
CHAPTER 4
Tutorials
4.1 Overview
This chapter provides tutorials for setting up your LTE3301.
• Set Up a Wireless Network Using WPS
• Connect to LTE3301 Wireless Network without WPS
• Using Multiple SSIDs on the LTE3301
4.2 Set Up a Wireless Network Using WPS
This section gives you an example of how to set up wireless network using WPS. This example uses
the LTE3301 as the AP and NWD210N as the wireless client which connects to a notebook.
Note: The wireless client must be a WPS-aware device (for example, a WPS USB adapter
or PCI card).
There are two WPS methods for creating a secure connection via the web configurator or utility.
This tutorial shows you how to do both.
• Push Button Configuration (PBC) - create a secure wireless network simply by pressing a
button. See Section 4.2.1 on page 30. This is the easier method.
• PIN Configuration - create a secure wireless network simply by entering a wireless client's PIN
(Personal Identification Number) in the LTE3301’s interface. See Section 4.2.2 on page 31. This is
the more secure method, since one device can authenticate the other.
4.2.1 Push Button Configuration (PBC)
1 Make sure that your LTE3301 is turned on. Make sure the WIFI button (at the back panel of the
LTE3301) is pushed in, and that the device is placed within range of your notebook.
2 Make sure that you have installed the wireless client (this example uses the NWD210N) driver and
utility in your notebook.
3 In the wireless client utility, find the WPS settings. Enable WPS and press the WPS button (Start or
WPS button)
4 Log into LTE3301’s Web Configurator and press the Push Button in the Configuration >
Network > Wireless LAN 2.4G > WPS Station screen.