Chapter 18 Universal Plug-and-Play (UPnP)
LTE3301 Series User’s Guide
119
All UPnP-enabled devices may communicate freely with each other without additional configuration.
Disable UPnP if this is not your intention.
18.3 UPnP Screen
Use this screen to enable UPnP on your LTE3301.
Click Management > UPnP to display the screen shown next.
Figure 78 Management > UPnP
The following table describes the fields in this screen.
18.4 Technical Reference
The sections show examples of using UPnP.
18.4.1 Using UPnP in Windows XP Example
This section shows you how to use the UPnP feature in Windows XP. You must already have UPnP
installed in Windows XP and UPnP activated on the LTE3301.
Make sure the computer is connected to a LAN port of the LTE3301. Turn on your computer and the
LTE3301.
18.4.1.1 Auto-discover Your UPnP-enabled Network Device
1 Click start and Control Panel. Double-click Network Connections. An icon displays under
Internet Gateway.
2 Right-click the icon and select Properties.
Table 54 Management > UPnP
LABEL DESCRIPTION
UPnP Select Enable to activate UPnP. Be aware that anyone could use a UPnP application to
open the web configurator's login screen without entering the LTE3301's IP address
(although you must still enter the password to access the web configurator).
Apply Click Apply to save the setting to the LTE3301.
Cancel Click Cancel to return to the previously saved settings.
To Next Page
Loading...
