Chapter 2 Introducing the Web Configurator
LTE3301 Series User’s Guide
20
The following table describes the sub-menus.
Table 6 Navigation Panel
LINK TAB FUNCTION
Status This screen shows the LTE3301’s general device, system and interface
status information. Use this screen to access the summary statistics tables.
Monitor
Log Use this screen to view the list of activities recorded by your LTE3301.
DHCP Table Use this screen to view current DHCP client information.
Packet Statistics Use this screen to view port status and packet specific statistics.
WLAN Station
Status
Use this screen to view the wireless stations that are currently associated
to the LTE3301’s 2.4GHz wireless LAN.
LTE Modem
Status
Use this screen to view the detailed information about the LTE module,
cellular interface, and SIM card. You can also view the LTE connection
status.
Configuration
Network
WAN Management
WAN
This screen allows you to configure ISP parameters, WAN IP address
assignment, and DNS servers.
Network
Scan
Use this screen to specify the type of the mobile network to which the
LTE3301 is connected and how you want the LTE3301 to connect to an
available mobile network.
IPv6 Use this screen to configure the LTE3301’s IPv6 settings.
Wireless LAN General Use this screen to enable the wireless LAN and configure wireless LAN and
wireless security settings.
More AP Use this screen to configure multiple BSSs on the LTE3301.
MAC Filter Use the MAC filter screen to allow or deny wireless stations based on their
MAC addresses from connecting to the LTE3301.
Advanced This screen allows you to configure advanced wireless LAN settings.
QoS Use this screen to configure Wi-Fi Multimedia Quality of Service (WMM
QoS). WMM QoS allows you to prioritize wireless traffic according to the
delivery requirements of individual services.
WPS Use this screen to configure the WPS settings.
WPS Station Use this screen to add a wireless station using WPS.
Scheduling Use this screen to schedule the times the Wireless LAN is enabled.
WDS Use this screen to enable and configure the WDS settings.
LAN IP Use this screen to configure LAN IP address and subnet mask.
DHCP Server General Use this screen to enable the LTE3301’s DHCP server.
Advanced Use this screen to assign IP addresses to specific individual computers
based on their MAC addresses and to have DNS servers assigned by the
DHCP server.
Client List Use this screen to view information related to your DHCP status.
NAT General Use this screen to enable NAT.
Port
Forwarding
Use this screen to configure servers behind the LTE3301 and forward
incoming service requests to the server(s) on your local network.
Port Trigger Use this screen to change your LTE3301’s port triggering settings.
ALG Use this screen to enable or disable SIP (VoIP) ALG (Application Layer
Gateway) in the LTE3301.
To Next Page
Loading...
