Chapter 1 Introduction
LTE Series User’s Guide
27
WiFi/WPS Green On The WiFi AP is activated.
Blinking
(fast)
Data is being transmitted and received.
Blinking
(slow)
The WPS is activated.
Voice Green On
A telephone connected to the PHONE port has its receiver off
the hook.
Blinking
The Zyxel Device is receiving an incoming call.
Off
A telephone connected to the PHONE port has its receiver on
the hook.
LAN Green On The Zyxel Device recognizes an Ethernet cable through the
LAN port.
Blinking The Zyxel Device is sending/receiving data through the LAN.
Off The wireless network is not activated.
Table 7 LTE3316-M604 LED Descriptions
LED COLOR STATUS DESCRIPTION
Power White On The Zyxel Device is receiving power and functioning
properly.
Blinking The Zyxel Device is in the process of starting up or default
restoring.
Off The Zyxel Device is not receiving power.
Internet White On The Zyxel Device’s WAN connection is ready, but there is no
traffic.
Blinking The Zyxel Device is transmitting and receiving data through
the WAN.
Off The WAN connection is not ready, or has failed.
LTE/3G Signal Strength White On The Zyxel Device is successfully connected to a 4G network.
Blinking The Zyxel Device is successfully connected to a 3G network.
Green On The Zyxel Device is successfully connected to an Ethernet
WAN network.
Signal Strength Green On The signal strength is good.
Orange On The signal strength is fair.
Red On The signal strength is poor.
Blinking A valid SIM card is inserted, but no signal is detected.
WLAN/WPS White On This indicates either 5G and 2.4G wireless LAN are both on or
the 5G wireless LAN is on.
Blinking This indicates either 5G and 2.4G WPS are both on or the 5G
WPS is on.
Green On The 2.4G wireless LAN is on, but the Zyxel Device is not
sending/receiving data through the wireless LAN.
Blinking The Zyxel Device is ready and the 2.4G WPS is on.
Table 6 LTE5388-M804 / LTE5398-M904 LED Descriptions (continued)
LED COLOR STATUS DESCRIPTION
To Next Page
Loading...
