Chapter 8 Control Panel: Network
NAS Series User’s Guide
131
8.4.2 Configure Network Interface
Use the Network Interface screen to edit the IPv4 or IPv6 settings of LAN 1 and LAN 2, set up port trunking,
and configure PPPoE settings. Click Control Panel > Network > TCP/IP > Network Interface in the
navigation panel to open the following screen.
Note: LAN 2 and port trunking are available only on the NAS which has multiple Ethernet
ports.
Figure 100 Control Panel > Network > TCP/IP > Network Interface
Apply Click this to save your TCP/IP configurations. After you click Apply, the NAS restarts. Wait
until you see the Login screen or until the NAS fully boots and then use the NAS Starter Utility
to rediscover it.
Reset Click this to restore your previously saved settings.
Table 74 Control Panel > Network > TCP/IP > General Settings (continued)
LABEL DESCRIPTION
To Next Page
Loading...
