ZyXEL Communications NAS326-2T - Configure Upnp Port Mapping

Chapter 8 Control Panel: Network
NAS Series User’s Guide
141
Figure 111 Network > UPnP Port Mapping > UPnP Router
The following table describes the labels in this screen.
8.5.5 Configure UPnP Port Mapping
Click Network > UPnP Port Mapping > UPnP Port Mapping to display the UPnP Port Mapping screen.
Use this screen to set how the Internet gateway’s UPnP feature configures the Internet gateway’s NAT IP
address mapping and port mapping settings. These settings allow Internet users connected to the
Internet gateway’s WAN interface to access services on the NAS. You can set which port Internet users
need to use to access a specific service on the NAS.
Table 82 Network > UPnP Port Mapping > UPnP Router
LABEL DESCRIPTION
Status This displays whether a UPnP router is found.
IP address This displays the IP address of the UPnP router.