Chapter 8 Control Panel: Network
NAS Series User’s Guide
142
Figure 112 Network > UPnP Port Mapping > UPnP Port Mapping
The following table describes the labels in this screen.
Table 83 Network > UPnP Port Mapping > UPnP Port Mapping
LABEL DESCRIPTION
Add Click this to add a service and create a port mapping rule.
See more details on Section 8.5.5.1 on page 143.
Remove Click this to open the following screen where you can remove a port mapping rule.
Click Yes to remove the selected port mapping rule or No to close this screen.
Enabled/Disabled Use this to enable or disable a selected port mapping rule.
Status Displays the status of the port mapping rule. A green circle indicates the port mapping rule is
enabled and you can access the service. A grey circle indicates the port mapping rule is
disabled. A red circle indicates the router’s settings failed to be changed. “-” indicates a new
mapping rule.
Service This read-only field identifies a service on the NAS.
LAN Port Displays the NAS’s internal port number for the service.
To Next Page
Loading...
